External wall insulation · Greater Manchester
External wall insulation in Urmston
If you're planning external wall insulation in Urmston, start with a free survey: we measure, check the walls and confirm planning and building control for your address. For homes in Urmston, the survey starts with the wall itself: solid brick, stone or concrete, and whether any old render is sound enough to insulate over.
- Free survey in M41 and nearby
- Guide price from £105 per m² + scaffold, 0% VAT
- Fixed written price before work starts
Free survey in Urmston
Postcode, service and a phone number is all we need.
What you get
- Typically takes a 225mm solid brick wall from around 2.1 W/m²K to about 0.30 W/m²K with 90–110mm of board
- Covers tired brick, pebble dash or failing render with a new finish
- Installing wall insulation in homes is currently zero-rated for VAT until 31 March 2027
- Work happens outside, so you can live at home throughout
Before we quote in Urmston
As well as Urmston itself, we quote in Stretford, Sale and Eccles. Urmston is about 5 miles from Manchester. The North West has one of the largest stocks of pre-1919 solid-wall terraces in England, alongside Pennine stone houses and post-war estates.
Exposure to wind-driven rain varies across Greater Manchester: sheltered town streets fare better than walls on high ground or facing the prevailing weather, and the render, beads and cill details are chosen with that in mind.
We plan EWI in Urmston around the details that cause trouble later — cills, eaves, downpipes and the base of the wall above the damp-proof course.
- Postcode district
- M41
- County or area
- Greater Manchester
- Nation
- England
- Nearby
- Stretford, Sale, Eccles, Swinton
Approvals in England
Planning in Urmston follows England's national rules: similar-looking finishes on houses are usually permitted, while flats, commercial premises, conservation areas and streets under an Article 4 direction need an application.
Insulating or re-rendering more than half of a wall's area brings in Part L of the Building Regulations, so building control is notified and the wall is upgraded to about 0.30 W/m²K where practical.
How does external wall insulation work?
Heat moves out through a wall faster when the wall is solid or poorly insulated. EWI wraps the outside face in a continuous layer of insulation, so the masonry stays on the warm side and the cold bridges at floor and party-wall junctions are reduced. The boards are bonded with adhesive and, on most walls, mechanically fixed. A base coat with an embedded glass-fibre mesh goes over the top, then a primer and the decorative finish.
Because the wall itself sits inside the insulation, it stays warmer and drier, and the rooms keep their full size. That is the main difference from internal insulation.
External wall insulation prices in Urmston
| Item | Guide price | Notes |
|---|---|---|
| EPS system with silicone render | £105–£145 per m²0% VAT | Most common choice for houses |
| Mineral wool system | £125–£170 per m²0% VAT | Non-combustible, vapour-open |
| Brick-slip finish over insulation | £185–£260 per m²0% VAT | Where a brick look is wanted |
| Three-bed semi, EPS + silicone (incl. scaffold) | £10,200–£17,7000% VAT | 80–100 m² of wall; depends on detailing and access |
Confirmed by a fixed written quote after survey. 0% VAT: installing insulation in a home is zero-rated until 31 March 2027, so these figures are the total; 5% applies from 1 April 2027.
How it works
Tell us about the property
Use the quote tool or form, or call. Photos help.
Free survey
We measure, check the walls and confirm approvals.
Fixed written quote
System, details, access, exclusions and VAT in writing.
Installation
Scheduled for suitable weather, with a clear programme.
External wall insulation in Urmston: questions
Can EWI go over pebble dash?
Usually yes. The dash is tested for adhesion and hollow areas; sound dash can be insulated over with additional mechanical fixings, while loose areas are removed first.
How long does external wall insulation last?
A well-installed render system is commonly expected to last 25–30 years or more, with occasional cleaning and inspection of sealants. The system manufacturer's documentation states the expected service life for the specific build-up.
Do I need planning permission for external wall insulation?
Often not for a house in England or Wales if the finish looks similar to the existing walls. You will usually need permission in a conservation area, on flats, on commercial buildings or where the appearance changes noticeably. Listed buildings need listed building consent. We check your address before quoting.
Do you cover Urmston?
Yes — we survey and quote external wall insulation in Urmston (M41) and nearby Stretford, Sale and Eccles, with a fixed written price before any work starts.