External wall insulation · Leicestershire
External wall insulation in Oadby
External wall insulation in Oadby: free survey, written specification and a fixed price, with the details that keep walls dry planned from the start. For homes in Oadby, the survey starts with the wall itself: solid brick, stone or concrete, and whether any old render is sound enough to insulate over.
- Free survey in LE2 and nearby
- Guide price from £105 per m² + scaffold, 0% VAT
- Fixed written price before work starts
Free survey in Oadby
Postcode, service and a phone number is all we need.
What the job covers
- Installing wall insulation in homes is currently zero-rated for VAT until 31 March 2027
- Typically takes a 225mm solid brick wall from around 2.1 W/m²K to about 0.30 W/m²K with 90–110mm of board
- Boards chosen for the wall: EPS, mineral wool, wood fibre or phenolic
- Covers tired brick, pebble dash or failing render with a new finish
What we look for in Oadby
As well as Oadby itself, we quote in Wigston, Leicester and Market Harborough. Oadby is about 3 miles from Leicester. Housing in the East Midlands includes Victorian terraces in the towns and cities, plenty of inter-war semis and post-war council estates, some of them system-built.
Much of Leicestershire sits in the lower wind-driven rain exposure bands, which keeps the choice of finishes wide — though hilltop, coastal and exposed gable walls can still need a tougher specification, so we check the actual site.
Whole-house jobs and single elevations are both quoted in Oadby; a cold gable or rear wall can be done on its own where it suits.
- Postcode district
- LE2
- County or area
- Leicestershire
- Nation
- England
- Nearby
- Wigston, Leicester, Market Harborough, Loughborough
England: planning and regulations
For a house in Oadby, external insulation or render is often permitted development if it looks similar to the existing walls; conservation areas, flats, commercial buildings and listed buildings need permission or consent, so we check your address first.
Insulating or re-rendering more than half of a wall's area brings in Part L of the Building Regulations, so building control is notified and the wall is upgraded to about 0.30 W/m²K where practical.
How does external wall insulation work?
Heat moves out through a wall faster when the wall is solid or poorly insulated. EWI wraps the outside face in a continuous layer of insulation, so the masonry stays on the warm side and the cold bridges at floor and party-wall junctions are reduced. The boards are bonded with adhesive and, on most walls, mechanically fixed. A base coat with an embedded glass-fibre mesh goes over the top, then a primer and the decorative finish.
Because the wall itself sits inside the insulation, it stays warmer and drier, and the rooms keep their full size. That is the main difference from internal insulation.
External wall insulation prices in Oadby
| Item | Guide price | Notes |
|---|---|---|
| EPS system with silicone render | £105–£145 per m²0% VAT | Most common choice for houses |
| Mineral wool system | £125–£170 per m²0% VAT | Non-combustible, vapour-open |
| Brick-slip finish over insulation | £185–£260 per m²0% VAT | Where a brick look is wanted |
| Three-bed semi, EPS + silicone (incl. scaffold) | £10,200–£17,7000% VAT | 80–100 m² of wall; depends on detailing and access |
Confirmed by a fixed written quote after survey. 0% VAT: installing insulation in a home is zero-rated until 31 March 2027, so these figures are the total; 5% applies from 1 April 2027.
How it works
Enquiry
Send your postcode and a few details.
Measured survey
Walls, damp, eaves, cills and services recorded.
Written price
A fixed price with the specification attached.
Work and handover
Installed, inspected and documents handed over.
External wall insulation in Oadby: questions
Does EWI need Building Regulations approval?
In England and Wales, usually. Insulating more than half of a wall's area, or more than a quarter of the building's whole external envelope, counts as renovating a thermal element, so building control needs to be involved and the wall should reach about 0.30 W/m²K where that's practical. Scotland and Northern Ireland have their own building standards processes.
Can EWI go over pebble dash?
Usually yes. The dash is tested for adhesion and hollow areas; sound dash can be insulated over with additional mechanical fixings, while loose areas are removed first.
Do I need planning permission for external wall insulation?
Often not for a house in England or Wales if the finish looks similar to the existing walls. You will usually need permission in a conservation area, on flats, on commercial buildings or where the appearance changes noticeably. Listed buildings need listed building consent. We check your address before quoting.
Do you cover Oadby?
Yes — we survey and quote external wall insulation in Oadby (LE2) and nearby Wigston, Leicester and Market Harborough, with a fixed written price before any work starts.