Mineral wool EWI · England
Mineral wool external wall insulation in Kent
Quotes for mineral wool external wall insulation in Kent set out the system, detailing, access and VAT position in writing. For homes in Kent near busy roads, mineral wool's sound reduction can be a reason to choose it.
- Free survey and fixed written price
- Guide price from £125 per m² + scaffold, 0% VAT
- Planning and building control checked for England
Free survey in Kent
Tell us the postcode and what you need.
What's included
- Non-combustible board (typically Euroclass A1 or A2-s1,d0 as part of the system)
- Heavier than EPS, so more fixings and careful handling
- Used on blocks of flats and buildings with storeys above 11m
- Finished in mineral or silicone render, or brick slip
- Vapour-open, so moisture in solid walls can dry outwards
Homes and walls in Kent
Homes across the South East range from inter-war semis and post-war estates, which are mostly cavity-walled, to older solid-walled cottages and Victorian town terraces.
Much of Kent sits in the lower wind-driven rain exposure bands, which keeps the choice of finishes wide — though hilltop, coastal and exposed gable walls can still need a tougher specification, so we check the actual site.
For homes in Kent near busy roads, mineral wool's sound reduction can be a reason to choose it.
- Nation
- England
- Region
- South East
- Towns covered
- Maidstone, Gillingham, Chatham, Tunbridge Wells, Folkestone, Ashford (Kent), Margate, Dartford…
- Guide price
- From £125 per m² + scaffold · 0% VAT
England: planning and regulations
For houses, external wall insulation and render are often permitted development where the finish looks similar to the existing walls. Planning permission is usually needed in conservation areas, National Parks, National Landscapes, the Broads and World Heritage Sites (where cladding a house in stone, artificial stone, pebble dash, render, timber, plastic or tiles isn't permitted development), for flats and maisonettes, for commercial buildings, under an Article 4 direction, or where the look changes noticeably. Listed buildings need listed building consent.
Renovating more than half of a wall's area — insulating it, or stripping and re-rendering it — or more than a quarter of the building's whole external envelope brings in the energy requirements of Part L, so building control needs to be involved and the wall should reach about 0.30 W/m²K where that's technically, functionally and economically feasible.
Combustible materials are banned in the external walls of relevant buildings 18 metres and over (regulation 7(2)), and Approved Document B guidance also covers residential buildings with a storey 11 metres or more above ground. Higher-risk buildings go through the Building Safety Regulator.
Why choose mineral wool over EPS?
Two reasons come up most: fire and moisture. Mineral wool doesn't burn, which is why guidance for taller residential buildings points to non-combustible external wall materials. It is also vapour-open, so a solid wall that holds some moisture can keep drying outwards through the insulation and render.
The trade-offs are weight and cost. Slabs are denser, need more fixings and take longer to install, so the price per m² is higher than EPS.
Mineral wool external wall insulation prices in Kent
| Item | Guide price | Notes |
|---|---|---|
| Mineral wool + mineral or silicone render | £125–£170 per m²0% VAT | Excluding scaffold |
| Mineral wool + brick slip | £195–£260 per m²0% VAT | Heavier slip systems need extra fixings |
| Three-bed semi, full house | £11,800–£20,2000% VAT | 80–100 m² of wall, including scaffold |
Confirmed by a fixed written quote after survey. 0% VAT: installing insulation in a home is zero-rated until 31 March 2027, so these figures are the total; 5% applies from 1 April 2027.
How it works
Get a guide price
Try the online quote tool for a ballpark figure.
Book the survey
A visit at a time that suits you.
Agree the quote
Nothing starts until you've signed the written price.
We do the work
Planned around weather, with you kept informed.
Mineral wool EWI in Kent: questions
Does mineral wool get wet?
It is water-repellent and protected by the render system. Like any insulation it must not be left exposed to rain during installation, so boards are covered and work stops in wet weather.
Is mineral wool needed for a bungalow?
Rarely for fire reasons. It may still be chosen on a damp-prone solid wall where a vapour-open build-up is wanted.
Is mineral wool better than EPS?
Not always better — different. Mineral wool wins on fire performance, breathability and acoustics; EPS wins on cost, weight and thinner boards for the same U-value. The wall, the building height and your priorities decide it.
Do you cover all of Kent?
Yes. We survey and quote mineral wool external wall insulation across Kent, including Maidstone, Gillingham, Chatham, Tunbridge Wells, Folkestone.
Do I need planning permission in England?
For houses, external wall insulation and render are often permitted development where the finish looks similar to the existing walls. We check your address before quoting.