Mineral wool EWI · West Midlands
Mineral wool external wall insulation in Solihull
If you're planning mineral wool external wall insulation in Solihull, start with a free survey: we measure, check the walls and confirm planning and building control for your address. For homes in Solihull near busy roads, mineral wool's sound reduction can be a reason to choose it.
- Free survey in B27 and nearby
- Guide price from £125 per m² + scaffold, 0% VAT
- Fixed written price before work starts
Free survey in Solihull
Postcode, service and a phone number is all we need.
What you get
- Non-combustible board (typically Euroclass A1 or A2-s1,d0 as part of the system)
- Vapour-open, so moisture in solid walls can dry outwards
- Used on blocks of flats and buildings with storeys above 11m
- Heavier than EPS, so more fixings and careful handling
Homes and walls in Solihull
As well as Solihull itself, we quote in Shirley, Birmingham and Kenilworth. It's roughly 7 miles from Solihull to Birmingham, the largest town in West Midlands. The West Midlands has large numbers of Victorian and Edwardian terraces, inter-war semis and post-war council estates, including concrete and steel-framed house types.
Much of West Midlands sits in the lower wind-driven rain exposure bands, which keeps the choice of finishes wide — though hilltop, coastal and exposed gable walls can still need a tougher specification, so we check the actual site.
Older solid-walled homes in Solihull can suit a vapour-open mineral wool build-up better than foam; the survey checks the wall first.
- Postcode district
- B27
- County or area
- West Midlands
- Nation
- England
- Nearby
- Shirley, Birmingham, Kenilworth, Redditch
England: planning and regulations
For a house in Solihull, external insulation or render is often permitted development if it looks similar to the existing walls; conservation areas, flats, commercial buildings and listed buildings need permission or consent, so we check your address first.
If the work covers more than half of a wall, or a quarter of the building's whole envelope, it counts as renovating a thermal element, with a target of about 0.30 W/m²K where feasible.
On residential buildings with a storey 11 metres or more above ground, guidance points to non-combustible external wall materials, and combustible materials are banned in relevant buildings 18 metres and over, so we specify mineral wool systems there.
Why choose mineral wool over EPS?
Two reasons come up most: fire and moisture. Mineral wool doesn't burn, which is why guidance for taller residential buildings points to non-combustible external wall materials. It is also vapour-open, so a solid wall that holds some moisture can keep drying outwards through the insulation and render.
The trade-offs are weight and cost. Slabs are denser, need more fixings and take longer to install, so the price per m² is higher than EPS.
Mineral wool external wall insulation prices in Solihull
| Item | Guide price | Notes |
|---|---|---|
| Mineral wool + mineral or silicone render | £125–£170 per m²0% VAT | Excluding scaffold |
| Mineral wool + brick slip | £195–£260 per m²0% VAT | Heavier slip systems need extra fixings |
| Three-bed semi, full house | £11,800–£20,2000% VAT | 80–100 m² of wall, including scaffold |
Confirmed by a fixed written quote after survey. 0% VAT: installing insulation in a home is zero-rated until 31 March 2027, so these figures are the total; 5% applies from 1 April 2027.
From enquiry to finished wall
Enquiry
Send your postcode and a few details.
Measured survey
Walls, damp, eaves, cills and services recorded.
Written price
A fixed price with the specification attached.
Work and handover
Installed, inspected and documents handed over.
Mineral wool EWI in Solihull: questions
Does mineral wool get wet?
It is water-repellent and protected by the render system. Like any insulation it must not be left exposed to rain during installation, so boards are covered and work stops in wet weather.
Is mineral wool better than EPS?
Not always better — different. Mineral wool wins on fire performance, breathability and acoustics; EPS wins on cost, weight and thinner boards for the same U-value. The wall, the building height and your priorities decide it.
Can mineral wool EWI have a brick finish?
Yes. Brick slips can be bonded over mineral wool systems designed for them, with additional fixings for the extra weight.
Do you cover Solihull?
Yes — we survey and quote mineral wool external wall insulation in Solihull (B27) and nearby Shirley, Birmingham and Kenilworth, with a fixed written price before any work starts.